CHESTNUT Cut 'n' Polish 225ml

Chestnut Cut 'n' Polish 225 ml

• Cut’n’Polish is a blend of two waxes with a fine abrasive held in suspension within them.
• This is a soft wax designed to stay ‘wet’ slightly longer during application, allowing it to lubricate the abrasive to give a very fine cut to the timber and also to collect any dust generated during use and some subsequent sanding, preventing it from entering the workshop atmosphere.
• On bare wood; sand to 240 grit as normal, apply a coat of Cut’n’Polish with the lathe stopped, then switch on the lathe and buff to a soft sheen whilst smoothing the timber at the same time.
• On sealed wood apply after the sealer in the same way, polishing to a slightly higher shine.
• Cut’n’Polish dries almost immediately and can be overcoated with Friction Polish or any of our waxes for a higher shine.
• Can be used in a similar way to Yorkshire Grit 

• Typical uses: To assist in finer finishing of turned workpieces
• Method of application: Cloth
• Drying time: Almost immediately
• Compatibility: Can be overcoated with friction polish or waxes.
• Tips: Sand to 240 grit , apply a thin coat whilst the lathe is stopped then carefully buff with the lathe switched on.
• Safety Considerations: Highly Flammable. Does not contain harmful solvents(see Safety Data Sheet or warnings on can for full details).

 Chestnut Safety Data Sheet - Cut 'n' Polish